Table of Contents
Advertisement
Interfaces
n
The default is Automatic.
c. For MTU,
n
n
n
The default is Automatic.
d. For Domain name suffix, type the domain name that should be appended to host names.
e. For Primary and Secondary DNS, Primary and Secondary NTP server, and Primary and
Secondary WINS server, select either:
n
n
n
f. For Bootfile name, type the relative path and file name of the bootfile on the TFTP server.
g. For TFTP server name, type the IP address or host name of the TFTP server.
10. See
Configure DHCP options
11. See
Map static IP addresses to hosts
12. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable the DHCP server for an existing LAN. For example, to enable the DHCP server for a LAN
named my_lan:
(config)> network interface my_lan ipv4 dhcp_server enable true
(config)>
See
Configure a LAN
4. (Optional) Set the amount of time that a DHCP lease is valid:
(config)> network interface my_lan ipv4 dhcp_server lease_time value
(config)>
Digi Connect IT® Mini User Guide
Custom: Allows you to identify the IP address of a Custom gateway to be
broadcast.
None: An MTU of length 0 is broadcast. This is not recommended.
Automatic: No MTU is broadcast and clients will determine their own MTU.
Custom: Allows you to identify a Custom MTU to be broadcast.
None: No server is broadcast.
Automatic: Broadcasts the Connect IT Mini device's server.
Custom: Allows you to identify the IP address of the server.
for information about Custom DHCP options.
for information about creating a LAN.
for information about Static leases.
Local Area Networks (LANs)
109
Advertisement
Table of Contents
