Table of Contents
Advertisement
Services
different buses that have the same Modbus address of 10, you can create two clients on
the gateway:
n
n
i. Repeat the above instructions for additional clients.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® Mini User Guide
Client one:
filter set to 10.
l
This will configure the gateway to deliver all messages that have the Modbus server
address of 10 to this device.
Client two:
filter set to 20.
l
adjust_server_address set to 10.
l
This will configure the gateway to deliver all messages that have the Modbus server
address address of 20 to the device with address 10.
Configure the Modbus gateway
324
Advertisement
Table of Contents
