Digi Connect IT Mini User Manual page 93

Interfaces
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
---------------- ----- ------- -------------------------------
defaultip
defaultlinklocal IPv4 up
eth
eth
loopback
modem
modem
>
3. Enter show network interface name at the Admin CLI prompt to display additional
information about a specific WAN. For example, to display information about ETH, enter show
network interface eth:
> show network interface eth
wan1 Interface Status
---------------------
Device
Zone
IPv4 Status
IPv4 Type
IPv4 Address(es) : 10.10.10.10/24
IPv4 Gateway
IPv4 MTU
IPv4 Metric
IPv4 Weight
IPv4 DNS Server(s) : 10.10.10.2, 10.10.10.3
IPv6 Status
IPv6 Type
IPv6 Address(es) : fe00:2404::240:f4ff:fe80:120/64
IPv6 Gateway
IPv6 MTU
IPv6 Metric
IPv6 Weight
IPv6 DNS Server(s) : fd00:244::1, fe80::234:f3f4:fe0e:4320
>
Digi Connect IT® Mini User Guide
command at the Admin CLI prompt:
Proto Status Address
IPv4 up 192.168.210.1/24
169.254.100.100/16
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
IPv4 up 10.200.1.101/30
IPv6 down
: eth
: external
: up
: dhcp
: 10.10.10.1
: 1500
: 1
: 10
: up
: dhcpv6
: ff80::234:f3ff:ff0e:4320
: 1500
: 1
: 10
Wide Area Networks (WANs)
93