Table of Contents
Advertisement
Command line interface
Access the command line interface
You can access the Connect IT Mini command line interface using an SSH connection, a telnet
connection, or a serial connection. You can use an open-source terminal software, such as PuTTY or
TeraTerm, to access the device through one of these mechanisms.
You can also access the command line interface in the WebUI by using the Terminal, or the Digi
Remote Manager by using the Console.
To access the command line, your device must be configured to allow access, and you must log in as a
user who has been configured for the appropriate access. For further information about configuring
access to these services, see:
Serial:
Configure the serial port
n
WebUI:
Configure the web administration service
n
SSH:
Configure SSH access
n
Telnet:
Configure telnet access
n
Log in to the command line interface
Command line
1. Connect to the Connect IT Mini device by using a serial connection, SSH or telnet, or the
Terminal in the WebUI or the Console in the Digi Remote Manager. See
line interface
For serial connections, the default configuration is:
n
l
l
l
l
l
For SSH and telnet connections, the default IP address of the device is 192.168.210.1
n
on the .
2. At the login prompt, enter the username and password of a user with Admin access:
login: admin
Password: **********
The default username is admin. The default unique password for your device is printed on the
device label.
3. Depending on the device configuration, you may be presented with another menu, for example:
Access selection menu:
a: Admin CLI
1: Serial: port1
q: Quit
Select access or quit [admin] :
Digi Connect IT® Mini User Guide
for more information.
115200 baud rate
8 data bits
no parity
1 stop bit
no flow control
(9600,8,1,none,none)
Access the command line interface
Access the command
584
Advertisement
Table of Contents
