Table of Contents
Advertisement
Virtual Private Networks (VPN)
a. For Type, select the method to determine the local network interface that is used to
communicate with the peer.
n
n
n
The default is Default route.
12. Click to expand GRE tunnel local endpoint.
a. For Type, select the local endpoint of the GRE endpoint negotiated by NEMO.
n
n
The default is Default route.
13. Click to expand Local networks.
a. For Add Interface, click gto add a local network to use as a virtual NEMO network
interface.
b. For Interface, select the local interface to use as a virtual NEMO network interface.
Generally, this will be the a Local Area Network (LAN).
c. (Optional) Repeat for additional interfaces.
14. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a NEMO tunnel. For example, to add a NEMO tunnel named nemo_example:
(config)> add vpn nemo nemo_example
(config vpn nemo nemo_example)>
Digi Connect IT® Mini User Guide
If Default route is selected, the network interface that is used will be the same as
the default route.
If Interface is selected, specify the local network interface.
If IP address is selected, type the IP address.
If Default route is selected, the network interface that is used will be the same as
the default route.
If Interface is selected, specify the local network interface.
NEMO
269
Advertisement
Table of Contents
