Table of Contents
Advertisement
Diagnostics
Example Ethernet capture filters
Capture Ethernet packets to and from a host with a MAC address of 00:40:D0:13:35:36:
n
ether host 00:40:D0:13:35:36
Capture Ethernet packets from host 00:40:D0:13:35:36:
n
ether src 00:40:D0:13:35:36:
Capture Ethernet packets to host 00:40:D0:13:35:36:
n
ether dst 00:40:D0:13:35:36
Capture packets from the command line
You can start packet capture at the command line with the
can schedule the network analyzer to run based on a specified event or at a particular time. See
Configure packet capture for the network analyzer
Additional analyzer commands allow you to:
Stop capturing
n
Save captured data traffic to a
n
Clear captured
n
Required configuration items
A configured packet capture. See
n
packet capture configuration information.
To start packet capture from the command line:
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> analyzer start name capture_filter
>
where capture_filter is the name of a packet capture configuration. See
capture for the network analyzer
To determine available packet capture configurations, use the ?:
> analyzer start name ?
name: Name of the capture filter to use.
Format:
test_capture
Digi Connect IT® Mini User Guide
packets.
file.
data.
Configure packet capture for the network analyzer
for more information.
analyzer start
command. Alternatively, you
for information about scheduling packet capturing.
Analyze network traffic
for
Configure packet
568
Advertisement
Table of Contents
