Table of Contents
Advertisement
Services
To limit access based on firewall zones:
n
a. Click Zones.
b. For Add Zone, click g .
c. For Zone, select the appropriate firewall zone from the dropdown.
d. Click gagain to allow access through additional firewall zones.
6. Multicast DNS (mDNS) is enabled by default. mDNS is a protocol that resolves host names in
small networks that do not have a DNS server. To disable mDNS, or enable it if it has been
disabled, click Enable mDNS.
7. For SSL certificate, if you have your own signed SSL certificate, type the certificate and private
key in PEM format. If SSL certificate is blank, the device will use an automatically-generated,
self-signed certificate.
Note
Password-protected certificate keys are not supported.
8. For Allow legacy encryption protocols, enable this option to allow clients to connect to the
HTTPS session by using encryption protocols older than TLS 1.2, in addition to TLS 1.2 and later
protocols. This option is disabled by default, which means that only TLS 1.2 and later encryption
protocols are allowed with HTTPS connections.
9. View is set to Auto by default and normally should not be changed.
10. Legacy port redirection is used to redirect client HTTP requests to the HTTPS service. Legacy
port redirection is enabled by default, and normally these settings should not be changed. To
disable legacy port redirection, click to expand Legacy port redirection and deselect Enable.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
To limit access to specified IPv4 addresses and networks:
n
(config)> add service web_admin acl address end value
(config)>
Where value can be:
Digi Connect IT® Mini User Guide
See
Firewall configuration
Configure the web administration service
for information about firewall zones.
282
Advertisement
Table of Contents
