Table of Contents
Advertisement
User authentication
If admin > level is set to read-only:
(config)> auth group admin acl admin level full
(config)>
7. Configure the local user:
a. Create a local user with the username admin1:
(config)> add auth user admin1
(config auth user admin1)>
b. Assign a password to the user:
(config auth user adminuser)> password password1
(config auth user adminuser)>
c. Assign the user to the admin group:
(config auth user adminuser)> add group end admin
(config auth user adminuser)>
8. Save the configuration and apply the change:
(config auth user adminuser)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Example 3: Multiple users with specific serial port access
Goal: To create two RADIUS users that do not have configuration access to the Connect IT Mini but
have access rights to specific serial ports.
In this example, we will create two users:
serialuser1 with access to serial port 1.
n
serialuser2 with access to serial ports 2, 4, and 8.
n
This example uses a FreeRadius 3.0 server running on ubuntu. Server configuration may vary
depending on the platforms or type of servers used in your environment.
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
Digi Connect IT® Mini User Guide
Example user configuration
444
Advertisement
Table of Contents
