Digi Connect IT Mini User Manual page 146

Routing
12. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a new routing policy:
(config)> add network route policy end
(config network route policy 0)>
New route policies are enabled by default. To disable:
(config network route policy 0)> enable false
(config network route policy 0)>
4. (Optional) Set the label that will be used to identify this route policy:
(config network route policy 0)> label "New route policy"
(config network route policy 0)>
5. Set the interface on the Connect IT Mini device that will be used with this route policy:
a. Use the ? to determine available interfaces:
(config network route policy 0)>interface ?
Interface: The network interface used to reach the destination. Packets that satisfy the
matching criteria will be routed through this interface. If the interface has a gateway then it will
be used as the next hop.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network route policy 0)> interface
Digi Connect IT® Mini User Guide
IP routing
146