Digi Connect IT Mini User Manual page 112

Interfaces
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Map static IP addresses to hosts
You can configure the DHCP server to assign static IP addresses to specific hosts.
Required configuration items
IP address that will be mapped to the device.
n
MAC address of the device.
n
Additional configuration items
A label for this instance of the static lease.
n
To map static IP addresses:
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See
5. Click to expand IPv4 > DHCP server > Advanced settings > Static leases.
6. For Add Static lease, click g .
7. Type the MAC address of the device associated with this static lease.
8. Type the IP address for the static lease.
Note The IP address here should be outside of the DHCP server's configured lease range. See
Configure a DHCP server
9. (Optional) For Hostname, type a label for the static lease. This does not have to be the device's
actual hostname.
10. Repeat for each additional DHCP static lease.
11. Click Apply to save the configuration and apply the change.
Command line
Digi Connect IT® Mini User Guide
for further information about the lease range.
Local Area Networks (LANs)
Configure a LAN.
112