Download Mibs - Digi Connect IT Mini User Manual

Hide thumbs Also See for Connect IT Mini:

Table of Contents

6. Set the password for the user that will be used to connect to the SNMP agent:

(config)> service snmp password pwd

7. (Optional) Set the port number for the SNMP agent. The default is 161.

(config)> service snmp port port

8. (Optional) Configure Multicast DNS (mDNS)

mDNS is a protocol that resolves host names in small networks that do not have a DNS server.

For the SNMP agent, mDNS is disabled by default. To enable:

(config)> service snmp mdns enable true

9. (Optional) Set the authentication type. Allowed values are MD5 or SHA. The default is MD5.

(config)> service snmp auth_type SHA

10. (Optional) Set the privacy passphrase. If not set, the password, entered above, is used.

(config)> service snmp privacy pwd

11. (Optional) Set the privacy protocol, either DES or AES. The default is DES.

(config)> service snmp privacy_protocol AES

12. Save the configuration and apply the change:

(config)> save

Configuration saved.

13. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.

Required configuration items

Enable SNMP.

To download a .zip archive of the SNMP MIBs supported by this device:

Digi Connect IT® Mini User Guide

Simple Network Management Protocol (SNMP)