Digi Connect IT Mini User Manual page 167

Hide thumbs Also See for Connect IT Mini:

Table of Contents

10. Configure the VRRP interface. The VRRP interface is defined in the Interface parameter of the

VRRP configuration, and generally should be a LAN interface:

To configure the VRRP interface:

a. Click to expand Network > Interfaces.

b. Click to expand the appropriate VRRP interface (for example, LAN1).

c. For backup devices, for Default Gateway, type the IP address of the VRRP interface on the

master device.

d. Configure the VRRP interface's DHCP server to use a custom gateway that corresponds to

one of the VRRP virtual IP addresses:

i. Click to expand DHCP Server > Advanced settings.

ii. For Gateway, select Custom.

iii. For Custom gateway, enter the IP address of one of the virtual IPs used by this VRRP

e. For backup devices, enable and configure SureLink on the VRRP interface. Generally, this

should be a LAN interface; VRRP+ will then monitor the LAN using SureLink to determine if

the interface has network connectivity and promote a backup to master if SureLink fails.

i. Click to expand IPv4 > SureLink.

ii. Click Enable.

Digi Connect IT® Mini User Guide

Virtual Router Redundancy Protocol (VRRP)