Table of Contents
Advertisement
Services
default setting is time.devicecloud.com.
To change the default value of the NTP server:
n
a. Click NTP servers.
b. For Server, type a new server name.
To add an NTP server:
n
a. Click NTP servers.
b. For Add Server, click g .
c. For Server, enter the hostname of the upstream NTP server that the device will use
d. Click gto add additional NTP servers. If multiple servers are included, servers are
Note
This list is synchronized with the list of servers included with NTP server configuration,
and changes made to one will be reflected in the other. See
server
for more information about NTP server configuration.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Set the timezone for the location of your Connect IT Mini device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
Africa/Accra
Africa/Addis_Ababa
Digi Connect IT® Mini User Guide
to synchronize its time.
tried in the order listed until one succeeds.
Configure the system time
Configure the device as an NTP
326
Advertisement
Table of Contents
