Table of Contents
Advertisement
Routing
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show the routing table
To display the routing table:
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Status > Routes.
The Network Routing window is displayed.
4. Click IPv4 Load Balance to view IPv4 load balancing.
5. Click IPv6 Load Balance to view IPv6 load balancing.
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type
You can limit the display to only IPv4 entries by using show route ipv4, or to IPv6 entries by
using show route ipv6. You can also display more information by adding the verbose option to
the show route and show route ip_type commands.
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® Mini User Guide
show
route:
Show the routing table
155
Advertisement
Table of Contents
