Table of Contents
Advertisement
Interfaces
b. For Reboot device, enable to instruct the device to reboot when the WAN connection is
considered to have failed.
Note
If both the Restart interface and Reboot device parameters are enabled, the
Reboot device parameter takes precedence.
c. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
d. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
e. For Attempts, type the number of probe attempts before the WAN is considered to have
failed.
f. For Response timeout, type the amount of time that the device should wait for a
response to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
11. (Optional) Repeat this procedure for IPv6.
12. Click Apply to save the configuration and apply the change.
Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or WWAN, or edit an existing one:
To create a new WAN or WWAN, see
n
a Wireless Wide Area Network
To edit an existing WAN or WWAN, change to the WAN or WWAN's node in the
n
configuration schema. For example, for a WAN or WWAN named my_wan, change to the
Digi Connect IT® Mini User Guide
Configure a Wide Area Network (WAN)
(WWAN).
Wide Area Networks (WANs)
or
Configure
48
Advertisement
Table of Contents
