Digi Connect IT Mini User Manual page 179

Hide thumbs Also See for Connect IT Mini:

Table of Contents

3. For Lease range end, type 250.

4. Click Advanced settings.

5. For Gateway, select Custom.

6. For Custom gateway, enter 192.168.3.3.

7. Click Apply to save the configuration and apply the change.

Command line

Task 1: Configure VRRP on device two

1. Log into the Connect IT Mini command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. At the command line, type config to enter configuration mode:

3. Create the VRRP instance:

(config)> add network vrrp VRRP_test

(config network vrrp VRRP_test)>

4. Enable the VRRP instance:

(config network vrrp VRRP_test)> enable true

(config network vrrp VRRP_test)>

5. Set the VRRP interface to ETH:

(config network vrrp VRRP_test)> interface /network/interface/eth

(config network vrrp VRRP_test)>

6. Add the virtual IP address associated with this VRRP instance.

(config network vrrp VRRP_test)> add virtual_address end 192.168.3.3

(config network vrrp VRRP_test)>

Digi Connect IT® Mini User Guide

Virtual Router Redundancy Protocol (VRRP)