Table of Contents
Advertisement
Serial port
10. Set the type of flow control used by the device to which you want to connect:
(config)> serial port1 flow type
Allowed values are:
none
n
rts/cts
n
xon/xoff
n
The default is none.
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show serial status and statistics
To show the status and statistics for the serial port:
É
WebUI
1. Log into the Connect IT Mini WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Connections, click Serial. The Serial Status page displays. See
information about the features in this page.
Command line
1. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the
show serial
> show serial
Label
Port Enable Mode Baudrate
-------- ----- ------ ----- --------
Serial 1 port1 true login 9600
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect IT® Mini User Guide
command:
Show serial status and statistics
Serial Status page
for
134
Advertisement
Table of Contents
