Syntax:
send
This command transmits one of the following telnet special characters to the last active telnet
session:
ao
ayt
brk
ec
el
For example, to send a break signal, type:
Syntax:
status
The status command displays information on the current telnet session (if any), including the
peer you are connected to, and the current mode. Here's an actual example:
#> status
Connection 1: sunny
Escape character is ^].
Page 62 Ÿ Command Reference
telnet_special_character
abort output
are you there?
break
erase character
erase line
send
esc character
escape
go ahead
ga
interrupt process
ip
no operation
nop
synchronize process
synch
send brk
status