Table of Contents
Advertisement
Interfaces
(config network interface my_wan)> ipv4 mgmt num
(config network interface my_wan)>
iv. Set the MTU:
(config network interface my_wan)> ipv4 mtu num
(config network interface my_wan)>
v. Configure how to use DNS:
(config network interface my_wan)> ipv4 use_dns value
(config network interface my_wan)>
where value is one of:
vi. Enable DHCP Hostname to instruct the Connect IT Mini device to include the device's
system name with DHCP requests as the Client FQDN option. The DHCP server can
then be configured to register the device's hostname and IP address with an
associated DNS server.
(config network interface my_wan)> ipv4 dhcp_hostname true
(config network interface my_wan)>
b. See
Configure SureLink active recovery to detect WAN/WWAN failures
about configuring active recovery.
7. (Optional) Configure IPv6 settings:
a. Enable IPv6 support:
(config network interface my_wan)> ipv6 enable true
(config network interface my_wan)>
b. Set the IPv6 type to DHCP:
(config network interface my_wan)> ipv6 type dhcpv6
(config network interface my_wan)>
c. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
Digi Connect IT® Mini User Guide
always: DNS will always be used for this WAN; when multiple interfaces have
n
the same DNS server, the interface with the lowest metric will be used for DNS
requests.
primary: Only use the DNS servers provided for this interface when the
n
interface is the primary route.
never: Never use DNS servers for this interface.
n
See
RFC4702
for further information about DHCP server support for the Client
n
FQDN option.
See
Configure system information
n
Mini device's system name.
Wide Area Networks (WANs)
for information about setting the Connect IT
for information
82
Advertisement
Table of Contents
