Table of Contents
Advertisement
System administration
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the reboot time:
(config>> system schedule reboot_time time
(config)>
where time is the time of the day that the device should reboot, using the format HH:MM. For
example, the set the device to reboot at two in the morning every day:
(config>> system schedule reboot_time 02:00
(config)>
If a value is set for reboot_time but the device is unable to synchronize its time with an NTP
server, the device will reboot after it has been up for 24 hours. See
about configuring NTP servers.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Reset the device to factory defaults
Resetting the device to factory defaults performs the following actions:
Clears all configuration settings. When the device restarts, it uses the default configuration.
n
Deletes all user files.
n
Erases all automatically generated keys.
n
Clears event and system log files.
n
You can reset the device in the WebUI, at the command line, or by using the Reset button on the
device. You can also reset the device to the default configuration without removing scripts, keys, and
logfiles by using the revert command.
Digi Connect IT® Mini User Guide
Reset the device to factory defaults
System time
for information
494
Advertisement
Table of Contents
