Table of Contents
Advertisement
Interfaces
k. Enable DHCP Hostname to instruct the Connect IT Mini device to include the device's
system name with DHCP requests as the Client FQDN option. The DHCP server can then
be configured to register the device's hostname and IP address with an associated DNS
server.
n
n
10. (Optional) Click to expand MAC address blacklist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address blacklist.
a. Click to expand MAC address blacklist.
b. For Add MAC address, click g .
c. Type the MAC address.
11. (Optional) Click to expand MAC address whitelist.
If there whitelist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Click to expand MAC address whitelist.
b. For Add MAC address, click g .
c. Type the MAC address.
12. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT Mini command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
To create a new WAN named my_wan:
n
(config)> add network interface my_wan
(config network interface my_wan)>
To edit an existing WAN named my_wan, change to the my_wan node in the
n
configuration schema:
Digi Connect IT® Mini User Guide
See
RFC4702
for further information about DHCP server support for the Client
FQDN option.
See
Configure system information
device's system name.
Wide Area Networks (WANs)
for information about setting the Connect IT Mini
80
Advertisement
Table of Contents
