Table of Contents
Advertisement
System administration
2. Log into the Connect IT Mini command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
3. Load the firmware image onto the device:
> scp host hostname-or-ip user username remote remote-path local local-path to local
where:
hostname-or-ip is the hostname or ip address of the remote host.
n
username is the name of the user on the remote host.
n
remote-path is the path and filename of the file on the remote host that will be copied to
n
the Connect IT Mini device.
local-path is the location on the Connect IT Mini device where the copied file will be
n
placed.
For example:
> scp host 192.168.4.1 user admin remote /home/admin/bin/Connect IT Mini-20.8.22.32.bin local
/etc/config/ to local
admin@192.168.4.1's password: adminpwd
Connect IT Mini->20.8.22.32.bin
>
4. Verify that the firmware file has been successfully uploaded to the device:
> ls /etc/config/
-rw-r--r-- 1 root
-rw-r--r-- 1 root
drw------- 2 root
-rw-r--r-- 1 root
drwxr-xr-x 2 root
...
>
5. Update the firmware by entering the
name:
> system firmware update file Connect IT Mini-20.8.22.32.bin
36632K
netflash: got "/etc/config/Connect IT Mini-20.8.22.32.bin", length=37511229
netflash: authentication successful
netflash: programming FLASH device /dev/flash/image
36633K 100%
Firmware update completed, reboot device
>
6. Reboot the device to run the new firmware image using the
> reboot
Rebooting system
>
Digi Connect IT® Mini User Guide
100% 36MB 11.1MB/s
root
37511229 May 16 20:10 Connect IT Mini-20.8.22.32.bin
root
2580 May 16 16:44 accns.json
root
4096 Apr 29 18:51 analyzer
root
47 Apr 30 06:59 dhcp.leases
root
4096 May 15 17:53 fcron
update firmware
Update system firmware
00:03
command, specifying the firmware file
reboot
command.
489
Advertisement
Table of Contents
