Set User; Set Wlan; Status; Show - Digi Connect Wi-SP User Manual

Digi Connect and ConnectPort TS Family command-line interface

set user

Use the set user command to configure a user.

set wlan

Use the set wlan command to configure wireless devices.
set wlan
Use the set wlan command to configure wireless devices.

status

Use the status command to display a list of sessions or outgoing connections made by the connect,
rlogin, or telnet commands for a Digi device. Use the status command to determine which of the
current sessions to close.

show

Use the show commands to display current settings on a Digi device.

telnet

Use the telnet command to establish an outgoing telnet connection, also known as a session.

who and kill

Use the who command to display a global list of connections. The list of connections includes those
associated with a serial port or the command-line interface.
Use the kill command to terminate active connections based on the ID number returned from the
who results.
Use the who command to determine any connections that are no longer needed, and end the
connections by issuing a kill command.

Administration

You can issue commands from the command-line interface to administer Digi Connect and
ConnectPort TS Family products. The following table displays several administration tasks and the
commands used to perform them. See the Digi Connect® Family Command Reference for more
complete command descriptions.
Administrative task
Backup/restore a configuration from a
TFTP server on the network
Digi Connect Family and ConnectPort TS Family
Command
backup
Administration
122