Table of Contents
Advertisement
Routing
b. Set the zone. For example:
See
interface: Matches the destination IP address to the selected interface's network
n
address. Set the interface:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
address: Matches the destination IPv4 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
Digi Connect IT® Mini User Guide
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> dst zone
(config network route policy 0)> dst zone external
(config network route policy 0)>
Firewall configuration
for more information about firewall zones.
(config network route policy 0)>dst interface ?
Interface: The network interface.
Format:
/network/interface/defaultip
/network/interface/defaultlinklocal
/network/interface/lan
/network/interface/loopback
/network/interface/modem
Current value:
(config network route policy 0)> dst interface
(config network route policy 0)> dst interface /network/interface/eth
(config network route policy 0)>
IP routing
150
Advertisement
Table of Contents
