Table of Contents
Advertisement
Interfaces
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Configure active recovery on ETH:
a. Click Network > Interface > ETH > IPv4 > SureLink.
b. For Interval, type 10s.
c. Click to expand Test targets.
d. Delete the existing test targets:
Click the menu icon (...) next to each target and select Delete.
e. For Add Test Target, click g .
f. For Test type, select Ping test.
g. For Ping host, type 43.66.93.111.
h. For Ping payload size, type 256.
4. Repeat the above step for Modem to enable SureLink on that interface.
5. Click Apply to save the configuration and apply the change.
Command line
Digi Connect IT® Mini User Guide
Wide Area Networks (WANs)
62
Advertisement
Table of Contents
