Digi Connect IT Mini User Manual page 309

Services
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service snmp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
5. Set the name of the user that will be used to connect to the SNMP agent.
(config)> service snmp username name
(config)>
Digi Connect IT® Mini User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
eth ETH
loopback Loopback
modem Modem
config)>
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be referred to by
packet
filtering rules and access control lists.
Additional Configuration
-------------------------------------------------------------------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Simple Network Management Protocol (SNMP)
309