Command Reference Guide
VLAN C
ONFIGURATION
To activate the VLAN Configuration mode, enter the vlan command at the Global Configuration mode
prompt. For example:
>enable
#configure terminal
(config)#vlan 1
(config-vlan 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect <#> <from interface> <slot/port> <tdm-group#> <to interface> <slot/port>
on page 28
do
on page 32
end
on page 33
exit
on page 34
shutdown
on page 35
All other commands for this command set are described in this section in alphabetical order.
media [ethernet]
on page 1164
name <vlan name>
state [active | suspend]
61200510L1-35E
C
OMMAND
on page 1165
on page 1166
Copyright © 2005 ADTRAN
VLAN Configuration Command Set
S
ET
1163