ADTRAN 1000R Series Command Reference Manual page 1175

Command Reference Guide
vlan <vlan id> state [active | suspend]
Use the vlan state command to change the state of the VLAN. Use the no form of this command to return
to the default setting.
Syntax Description
<vlan id>
active
suspend
Default Values
The default setting is active (once the VLAN has been created).
Applicable Platforms
This command applies to the NetVanta 300, 1000, 1000R, and 2000 Series units.
Command History
Release 5.1
Usage Examples
The following example sets the VLAN state to suspended:
(config)#vlan database
(vlan)#vlan 2 state suspend
61200510L1-35E
Specifies a valid VLAN interface ID (1 to 4094).
Changes the VLAN state to active.
Changes the VLAN state to suspended.
Command was introduced.
Copyright © 2005 ADTRAN
VLAN Database Configuration Command Set
1175