Transmission Fluid Temperature Sensor Inspection; Solenoid Valves (Shift Solenoid Valves, Tcc Solenoid Valve And Pressure Control Solenoid Valve) Removal And Installation - Suzuki 2006 SX4 Service Manual

5A-76 Automatic Transmission/Transaxle:
3) Lift up vehicle.
4) With engine is cool, drain A/T fluid referring to "A/T
Fluid Change".
5) Remove transmission fluid temperature sensor (1)
with O-ring.
Installation
1) Apply A/T fluid to new O-ring.
2) Install new O-ring to transmission fluid temperature
sensor.
3) Install transmission fluid temperature sensor (1), and
tighten A/T fluid temperature sensor to specified
torque.
Tightening torque
Transmission fluid temperature sensor: 10 N·m (
1.0 kgf-m, 7.5 lb-ft)
4) Pour A/T fluid referring to "A/T Fluid Change".
5) Connect transmission fluid temperature sensor
connector (1).
1
6) Connect negative cable.
7) Verify that there is no A/T fluid leakage.
Transmission Fluid Temperature Sensor
Inspection
1) Remove transmission temperature sensor referring
to "Transmission Fluid Temperature Sensor Removal
and Installation".
2) Immerse temperature sensing part of sensor (1) in A/
T fluid and check resistance between sensor
terminals while heating A/T fluid gradually. If check
result is not as specified, replace sensor.
After inspection, install transmission fluid temp.
sensor and connect connector.
Transmission fluid temperature sensor
resistance (Temperature: Resistance)
0 °C (32 °F): 1844 – 2290 Ω
1
160 °C (320 °F): 19.2 – 22.2 Ω
I4RH01510035-01
Solenoid Valves (Shift Solenoid Valves, TCC
Solenoid Valve and Pressure Control Solenoid
Valve) Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Drain A/T fluid referring to "A/T Fluid Change".
3) Remove transaxle side cover (1).
1
I4RH01510035-01
I7RW01510039-01
S6RW0C5106020
1
I4RH01510036-01
S6RW0C5106021
1
I4RH01510038-01