1C-11 Engine Electrical Devices:
3) Check that there is no continuity between terminal
"c" and "d".
If there is continuity, replace relay.
4) Connect battery positive (+) terminal to terminal "b"
of relay. Connect battery negative (–) terminal "a" of
relay.
Check continuity between terminal "c" and "d".
If there is no continuity when relay is connected to
the battery, replace relay.
Pre-Heating Unit Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect pre-heating unit connector (1).
3) Remove pre-heating unit (2) from bracket.
2
1
Installation
Reverse removal procedure for installation.
Boost Pressure Control Solenoid Valve
Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Detach boost pressure control solenoid valve (1).
3) Disconnect boost pressure control solenoid valve
connector (2) and hoses (3) from boost pressure
control solenoid valve.
I4SN0A132024-01
S5JB0B1306023
Installation
Reverse removal procedure for installation.
I5JB0B130013-01
1
3
2
S5JB0B1306029
I5JB0B130014-02