Timing Chain Cover Cleaning And Inspection - Suzuki Liana RH418 Supplementary Service Manual

1D-24 Engine Mechanical:
8) Install cap (3) to timing chain cover (1).
Tighten bolts to specified torque.
Tightening torque
Cap bolt (c): 25 N·m (2.5 kgf-m, 18.0 lb-ft)
3
2
(c)
(b)
(a)
9) Install new O-ring (1) to oil gallery pipes No.2 (2) and
No.3 (3).
10) Install oil gallery pipes No.2 and No.3 to cylinder
head (4) and timing chain cover (5).
Tighten bolts to specified torque.
Tightening torque
Oil gallery pipe No.2 and No.3 bolt (a): 11 N·m (
1.1 kgf-m, 8.0 lb-ft)
(a)
4
5
11) Install water pump pulley.
12) Install P/S pump bracket (if equipped).
13) Install cylinder head cover referring to "Cylinder
Head Cover Removal and Installation".
14) Install oil pan referring to "Oil Pan and Oil Pump
Strainer Removal and Installation in Section 1E".
1
I3RH0B140026-01
(a)
1
2
3
I3RH0B140027-01
15) Install crankshaft pulley (1). Tighten bolt (2) to
specified torque. To lock crankshaft pulley, use
special tool with it as shown in the figure.
Special tool
(A): 09917–68221
Tightening torque
Crankshaft pulley bolt (a): 150 N·m (15.0 kgf-m,
108.5 lb-ft)
16) Install engine assembly to vehicle referring to
"Engine Assembly Removal and Installation".

Timing Chain Cover Cleaning and Inspection

Clean
Clean sealing surface on timing chain cover, cylinder
block and cylinder head.
Remove oil, old sealant, and dust from sealing surface.
Inspection
Oil seal
Check oil seal lip for fault or other damage. If damage is
found, replace oil seal referring to "Timing Chain Cover
Removal and Installation".
Timing chain cover
Inspect strainer (1) of oil passage for driving intake cam
timing sprocket assembly (VVT actuator).
If clog or foreign matter exists, clean strainer.
1
I2RH0B140056-01
S3RH0B1406016
I3RH0B140028-01