Shift Solenoids. Duty Solenoids And Atf Temperature Sensor - Subaru IMPREZA 2002 Service Manual

SHIFT SOLENOIDS, DUTY SOLENOIDS AND ATF TEMPERATURE SENSOR
AUTOMATIC TRANSMISSION
I
17.Shift Solenoids, Duty Sole-
noids and ATF Temperature
Sensor
A: REMOVAL
1) Set the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Lift-up the vehicle.
4) Clean the transmission exterior.
5) Drain the ATF completely.
NOTE:
Tighten the ATF drain plug after draining the ATF.
Tightening torque:
25 Nom (2.5 kgf-m, 18.1 ff-lb)
c-
.
(A) Oil pan
(B) Drain plug
6) Remove the oil pan.
7) Disconnect the solenoid and sensor connectors.
Remove the connectors from clip and disconnect
the connectors.
I
( G ) ( F )
B2M2263J
Lock-up duty solenoid (Blue)
Low clutch timing solenoid (Gray)
Line pressure duty solenoid (Red)
Shift solenoid 2 (Yellow)
Shift solenoid 1 (Green)
2-4 brake timing solenoid (Black)
2-4 brake duty solenoid (Red)
ATF temperature sensor
Transfer duty solenoid (Brown)
8) Remove the solenoids, duty solenoids and ATF
temperature sensor.
(A) Lock-up duty solenoid (Blue)
(B) Low clutch timing solenoid (Gray)
(C) Line pressure duty solenoid (Red)
(D) Shift solenoid 2 (Yellow)
(E) Shift solenoid 1 (Green)
(F) 2-4 brake timing solenoid (Black)
(G) 2-4 brake duty solenoid (Red)
(H) ATF temperature sensor
1. TRANSFER DUTY SOLENOID AND
TRANSFER VALVE BODY
1) Set up the vehicle on the lift.
2) Disconnect the ground terminal from battery.
3) Remove the air intake duct. <Ref. to IN(S0HC)-
7, REMOVAL, Air Intake Duct.>
4) Remove the air cleaner case. <Ref. to IN(S0-
HC)-6, REMOVAL, Air Cleaner Case.>
5 ) Remove the intercooler. (Turbo model) <Ref. to
IN(D0HC TURBO)-1 0, REMOVAL, Intercooler.>
6) Remove the pitching stopper.
7) Remove the front exhaust pipe with center ex-
haust pipe. (Non-turbo model)
With OBD
<Ref. to EX(S0HC)-5, REMOVAL, Front Exhaust
Pipe.>
8) Remove the center exhaust pipe. (Turbo model)
<Ref. to EX(D0HC TURBO)-8, REMOVAL, Center
Exhaust Pipe.>
AT-39