Toyota Celica 2005 Repair Manual page 887

DI−688
N
R
P
Bolt
12. MECHANICAL SYSTEM TESTS
(a) Measure the stall speed.
The object of this test is to check the overall performance of the transaxle and engine by measuring
the stall speeds in the D and R positions.
NOTICE:
Do the test at normal operating fluid temperature 50 to 80 °C (122 to 176 °F).
S
Do not continuously run this test for longer than 10 seconds.
S
To ensure safety, conduct this test in a wide, clear level area which provides good traction.
S
The stall test should always be carried out in pairs. One technician should observe the condi-
S
tions of wheels or wheel stoppers outside the vehicle while the other is doing the test.
(1) Chock the 4 wheels.
(2) Connect an OBD II scan tool or hand−held tester to DLC3.
(3) Fully apply the parking brake.
(4) Keep your left foot pressed firmly on the brake pedal.
(5) Start the engine.
(6) Shift into the D position. Press all the way down on the accelerator pedal with your right foot.
Quickly read the stall speed at this time.
Stall speed: 2,370 ± 150 rpm
2005 CELICA (RM1131U)
DIAGNOSTICS
D07260
(f)
Neutral Basic
Line
If it is not as stated above, carry out the following adjustment
procedures.
Bolt
Groove
D07257
(g)
− AUTOMATIC TRANSAXLE (U240E)
(3) Return the control shaft lever 2 notches to N posi-
tion.
(4) Set the shift lever to N position.
(5) While holding the shift lever lightly toward the R
position side, tighten the shift lever nut.
Torque: 13 N·m (130 kgf·cm, 9 in.·lbf)
(6) Start the engine and make sure that the vehicle
moves forward when shifting the lever from the N to
D position and reverses when shifting it to the R
position.
Inspect and adjust the park/neutral position.
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
(1) Loosen the park/neutral position switch bolt and set
the shift lever to the N position.
(2) Align the groove and neutral basic line.
(3) Hold in position and tighten the bolt.
Torque: 5.4 N·m (55 kgf·cm, 48 in.·lbf)
For continuity inspection of the park/neutral position
switch, see page DI−701.
Check the idle speed.
Idle speed: 650 ± 50 rpm
(In N position and air conditioner OFF)
886