Toyota Celica 2005 Repair Manual page 886

Add fluid
70 to 80°C (158 to 176°F)
2005 CELICA (RM1131U)
DIAGNOSTICS
If the level is at the low side, add new fluid.
NOTICE:
Do not overfill.
(b)
If the fluid smells burnt or is black, change it.
(c)
D07261
AT8562
OK
NOTICE:
Do not overfill.
(d)
If there are leaks, it is necessary to repair or replace O−rings,
gaskets, oil seals, plugs or other parts.
AT3417
(e)
If the indicator is not aligned with the correct position, carry out
the following adjustment procedures.
D07258
− AUTOMATIC TRANSAXLE (U240E)
(5) Pull it out and check that the fluid level is in the HOT
range.
Fluid type: ATF Type T−IV
Capacity: 4.1 liters (4.3 US qts, 3.6 lmp. qts)
Check the fluid condition.
Replace the ATF.
(1) Remove the drain plug and drain the fluid.
(2) Reinstall the drain plug securely.
(3) With the engine OFF add new fluid through the oil
filler pipe.
Fluid type: ATF Type T−IV
Capacity: 4.1 liters (4.3 US qts, 3.6 lmp. qts)
(4) Start the engine and shift the shift lever into all posi-
tions from P to L position and then shift into P posi-
tion.
(5) With the engine idling, check the fluid level. Add
fluid up to the COOL level on the dipstick.
(6) Check the fluid level at the normal operating tem-
perature, 70 to 80 °C (158 to 176 °F), and add as
necessary.
Check the fluid leaks.
Check for leaks in the transaxle.
Inspect and adjust the shift lever position.
When shifting the shift lever from the N position to other
positions, check that the lever can be shifted smoothly
and accurately to each position and that the position indi-
cator is aligned with the correct position.
(1) Loosen the nut on the shift lever.
(2) Push the control shaft fully downward.
885
DI−687