Figure 6-2 Measurement After Dispense And Measurement Together With - Thermo Scientific Varioskan User Manual

Protocols
Measurement with dispensing
90 Thermo Scientific SkanIt
measurement starts. The delay is caused when the plate is moved from
dispensing position to the measurement position.
Figure 6-2. Measurement after dispense and measurement together with dispense
Select Steps > Kinetic Loop and below the kinetic loop, select Steps >
Dispense and then Steps > [measurement].
You can modify the dispensing parameters (see Dispense" on page 120) by
selecting the Dispense step from the Steps step tree.
Use the Dispense at reading parameter if you want to specify that dispensing
is started only after a number of readings. Select at which reading the
dispensing will be performed. The possible values are from 1 to the number
of readings defined for the kinetic loop, the default being 1.
® ®
Software for Varioskan User Manual Thermo Fisher Scientific