Table of Contents
Advertisement
Section 10
Accessories
Feedwater Float or
Pressure Sw. (cont.)
Dispense Overflow
Cutoff Float
10-2
Nanopure Life Science (UV/UF)
5. Remove the jumper plug from the back, upper left portion of the unit
and save for future use.
6. Plug the cable into the jumper plug outlet.
7. Reconnect the electrical power.
Accessory AY1367X1 (overflow float with 6 ft [2.83 meter] cable) is
designed as a user option to ensure automatic dispensers (time or
volumetric) do not overflow carboy style containers. This accessory can be
especially helpful if the actual volume of a container is unknown. It can
also protect against overflows if the entered/stored volume of a previous
container has not been changed and is set for a volume greater than the
carboy being filled. Finally, the accessory can be useful for automatic time
dispenses as it is usually difficult to ensure the set time will equal a specific
volume of water.
Caution This accessory is not intended for use with small containers as its
weight could cause small, lightweight containers to tip over.
Note If an auto dispense is stopped by the AY1367X1, the Nanopure will
change modes to normal recirculation.
Figure 10-2. AY1367X1 Dispense Overflow Cutoff Float
s
s
Thermo Scientific
Advertisement
Table of Contents
