Figure 7-4 Multipoint Example: Measurement Points In A Well And Their; Figure 7-5 Multipoint Selection: Center Point Of A Well On A 48-Well Plate (A) And On A 6-Well Plate (B) - Thermo Scientific Varioskan User Manual

Thermo Fisher Scientific
Figure 7-4. Multipoint example: measurement points in a well and their
coordinates in the results
Figure 7-5. Multipoint selection: center point of a well on a 48-well plate (A) and
on a 6-well plate (B)
Purple points in the well are not selected; orange points are selected for
measurement. You can select a rectangular area by dragging with the mouse.
You can select several areas by holding the Ctrl key down while you drag.
You can also select several single points in a well by holding the Ctrl key
down while you select.
Note If there are not any points selected in the multipoint
measurement, the protocol cannot be run.
Select all - Selects the entire well.
Clear all - Clears all selections from the well.
Horizontal line across well - Selects a horizontal line in the middle of
the well.
Vertical line across well - Selects a vertical line in the middle of the well.
Thermo Scientific SkanIt
Using multipoint in a measurement
® ®
Software for Varioskan User Manual
Step Parameters
115