Chapter 7
Step Parameters
Step parameters are described in the following sections:
Area definition
Select Steps > Area Definition or click the
button on the action panel.
For more information, see Area definition" on page 85.
Well loop
Select Steps > Well Loop or click the
button on the action panel.
For more information, see Well loops" on page 87.
Photometric
The Photometric Measurement step is used to measure absorbance (Abs). In
the photometric calibration procedure the instrument reads the air blank
measurement
level. In long measurement procedures calibration is performed in a suitable
phase without disturbing the measurement timing. The calibration is valid
for 1 hour.
Select Steps > Photometric or click the
button on the action panel.
The photometric measurement step includes the following parameters:
®
®
Thermo Fisher Scientific
Thermo Scientific SkanIt
Software for Varioskan
User Manual
93