Adding Samples To The Plate Layout Using Fill Wizard - Thermo Scientific Varioskan User Manual

Plate Layouts
Editing a plate layout
Adding samples to the plate
layout using Fill Wizard
128 Thermo Scientific SkanIt
Properties panel of the Plate Layout view (see Editing sample properties
and adding samples with Sample Properties" on page 134).
The Fill Wizard is used to provide each sample with a unique name and
to assign them with a type (blank, calibrator, control, empty or unknown)
so that they can be used in calculations. Click the Fill Wizard button.
The Fill Wizard dialog opens.
The dialog has the following selections:
Plate view:
The plate indicated by Plate is shown on the right and the wells filled will
be shown in color. The well from which the filling will start is indicated by
a bright red dot. You can change the well from which you start filling by
clicking it. If you start filling from the right side of the plate, remember to
change the Filling order arrows accordingly (see below).
Samples:
® ®
Software for Varioskan User Manual Thermo Fisher Scientific