Thermo Scientific Varioskan User Manual page 73

Thermo Fisher Scientific
• Abort - If you want to abort the execution in the middle of the
measurement, click Abort.
When the measurement is finished, the Execution Progress dialog is
closed and the software will load the results to the Results view, which
shows the measurement results in the plate layout format (Table). The
measurement value is shown for each well in end-point measurements
and the curve in kinetic and spectrum scanning measurements.
You can also view the results in a list format by clicking the List tab.
The measurement and calculation data is automatically saved to the
database each time the session is run.
Click the calculation name in the Results steplist on the left to view
the calculation results. For more information on the different ways
you can view and manipulate measurement and calculation results, see
Chapter 11: Results".
Note When a session has been executed, you can no longer edit
it. You can only make changes to the calculations of the run that
is currently open and these calculation results can be saved.
However, when the session is run again, the new run will have the
original calculation parameters. If you want to change the
calculations permanently, save the session with a new name.
9. If you have more than one plate in the plate layout, the software
prompts you to insert the subsequent plates into the instrument after
measuring the previous plate.
When you have inserted the plate, click OK. The measurement starts.
Thermo Scientific SkanIt
® ®
Software for Varioskan User Manual
Executing a Session
71