Thermo Scientific Varioskan User Manual page 72

Executing a Session
70 Thermo Scientific SkanIt
The Execution Progress dialog is launched and the measurement
starts.
The Execution Progress dialog shows the plate layout to be measured.
The dialog displays measurement information while measuring. The
well that is being measured is framed in red. The measurement values
are shown in each well. In multipoint measurements, the last shown
value is a mean value of the measured points in a well. In spectrum
scanning, kinetic and TRF decay measurements, the measurement
curves are shown in each well instead of values.
•
•
•
•
•
•
•
•
® ®
Software for Varioskan User Manual
Run started - Shows when the execution was started (the date and
time).
Current step - Shows the step being executed.
Step state - Shows the state of the execution.
Run name - Shows the name of the run you gave.
Last value - Displays the value of the last read measurement.
Minimum - Displays the minimum value that has been measured
up to the point.
Maximum - Displays the maximum value that has been measured
up to the point.
Reading - Shows the ordinal of the execution loop (kinetic loop
or well loop).
Thermo Fisher Scientific