Merge Data; Graph - Thermo Scientific Varioskan User Manual

Data Processing Parameters

Graph

Merge data

198 Thermo Scientific SkanIt
Merge data calculation is used to combine measurement data and
measurement times from separate measurement steps into one data set. You
can only combine raw measurement data from measurements with the same
measurement technology. It is possible to combine data from both endpoint
and kinetic measurements. Data from spectral scanning measurements
cannot be combined.
Select Data Processing > Merge Data, click the
action panel, or right-click the measurement in the Results steplist.
Select the measurements whose data to combine. The combined data is
shown as a kinetic curve for each well in the table view and as a kinetic data
list in the list view. You can also perform calculations on the combined data
using calculations available for kinetic measurements.
Graph
You can create graphs from the measurement results. Unlike most other
calculations, the graph should only be created after the session is executed.
Select Data Processing > Graph, click the
panel, or right-click the measurement in the Results tree.
® ®
Software for Varioskan User Manual
button on the Results
button on the Results action
Thermo Fisher Scientific