Connecting The Instrument To The Pc Through A Usb Port; Figure 2-1 Computer And Mains Power Supply Connectors In The Varioskan Instrument - Thermo Scientific Varioskan User Manual

Installing SkanIt Software
Communicating with instruments
Connecting the instrument
to the PC through a USB
38 Thermo Scientific SkanIt
Figure 2-1. Computer and mains power supply connectors in the Varioskan
instrument
4. Switch ON the instrument and then the PC.
5. Launch SkanIt Software as described in Launching SkanIt Software"
on page 54.
6. After startup the instrument is ready for operation. Since the instrument
calibrates itself, you can start measuring immediately as soon as the
instrument has been turned on. However, the stabilization of the
incubator can take up to 10 minutes.
It is further recommended to carry out an empty run to verify proper
instrument operation.
If you want to use your instrument through the USB port, proceed as
follows. You have to have the USB Driver installed (see Installing software
port
prerequisites" on page 23, Step 2). You should also have the SkanIt Software
Setup CD-ROM in the CD drive of your computer.
1. Turn off the instrument.
2. Connect the instrument to the computer using a USB cable (see
Figure 2-1).
3. Turn on the instrument. The computer will recognize a new hardware.
® ®
Software for Varioskan User Manual Thermo Fisher Scientific