Suzuki Liana RH413 Service Manual page 223

4) Remove cylinder head cover and oil pan referring to
"Cylinder Head Cover Removal and Installation" and
"Oil Pan and Oil Pump Strainer Removal and
Installation in Section 1E".
5) Remove P/S pump bracket (if equipped).
6) Remove water pump pulley.
7) Remove timing chain cover (1).
Installation
1) Install oil seal (1) to timing chain cover, if removed.
NOTE
When installing new oil seal (1), press fit to
timing chain cover (2) by using special tool
(bearing installer) as shown in the figure.
Special tool
(A): 09913–75810
Oil seal installation depth
"a": 1.5 mm (0.06 in.)
2) Apply sealant "A" to mating surface between cylinder
and cylinder head, and apply sealant "B" to mating
surface of timing chain cover as shown in the figure.
"A": Sealant 99000–31140
"B": Water tight sealant 99000–31250
Sealant amount for timing chain cover
Width "a": 3 mm (0.12 in.)
Height "b": 2 mm (0.08 in.)
I2RH0B140052-01
I2RH0B140053-01
3) Apply engine oil to oil seal lip, then install timing
chain cover (1). Tighten bolts and nut to specified
torque.
NOTE
Before installing timing chain cover, check
that pin is securely fitted.
Tightening torque
Timing chain cover bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
I2RH0B140058-01
Engine Mechanical: 1D-18
I2RH0B140054-01
I2RH0B140055-01