Ethernet Configuration" Page; Table 77: Wbm "Ethernet Configuration" Page - "Bridge Configuration" Group; Table 78: Wbm "Ethernet Configuration" Page - "Ethernet Interface - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

15.2.1.2.3 "Ethernet Configuration" Page

The settings for ETHERNET are located on the "Ethernet Configuration" page.
"Bridge Configuration" Group
Table 77: WBM "Ethernet Configuration" Page – "Bridge Configuration" Group
Parameter
Bridge 1 ... <n>
Click the [Submit] button to apply the change. The change takes effect
immediately.
"Ethernet Interface Configuration" Group
Table 78: WBM "Ethernet Configuration" Page – "Ethernet Interface Configuration" Group
Parameter
Interface X<n>
Enabled
MAC Learning
Speed/Duplex
Click [Submit] to apply changes. The changes take effect immediately.
Meaning
Assign the physical ports X1... X <n> to a logical
bridge.
To do so, click the respective option button. The
assignment is marked in color.
A port can only be assigned to one bridge at a time.
Meaning
A separate area is displayed for each interface in
the controller.
You can enable or disable the interface.
You can disable or enable "MAC Learning".
Select the transmission speed and the transmission
method.
The drop-down menu is generated depending on the
device and interface.
When "Autonegotiation" is selected, the connection
modalities are negotiated automatically between the
peer devices.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 179
Manual