Configuration Of Snmp V3 Users" Page; Table 107: Wbm "Configuration Of Snmp V3" Page - "Actually Configured V3 - WAGO Compact Controller 100 Manual

174 Appendix

15.1.1.2.23 "Configuration of SNMP v3 Users" Page

The general settings for SNMP v3 are shown on the "Configuration of SNMP v3
Users" page.
"Actually configured v3 Users" Group
Table 107: WBM "Configuration of SNMP v3" Page – "Actually configured v3 Users" Group
Parameters
User <n>
Security Authentication
Name
Authentication Type
Authentication Key
Privacy
Privacy Key
Notification Receiver IP
Add new v3 User
Security Authentication
Name
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
751-9301 Compact Controller 100
Meaning
Each configured v3 user has its own area in the
display. If no v3 user has been configured, "(no trap
receivers configured)" is displayed.
The user name is displayed.
The authentication type for the SNMP v3 packets is
displayed.
Possible values:
- Use no authentication ("None")
- Message Digest 5 ("MD5")
- Secure Hash Algorithm ("SHA")
The authentication key is displayed.
The encryption algorithm for the SNMP message is
displayed.
Possible values:
- No encryption ("None")
- Data Encryption Standard ("DES")
- Advanced Encryption Standard ("AES")
The key for encryption of the SNMP message is
displayed. If nothing is displayed, the "authentication
key" is automatically used.
The IP address of a trap receiver for v3 traps is
displayed. If no v3 traps are to be sent for this user,
this field remains blank.
In this area, you can enter a new v3 user. You can
create up to 10 users.
Enter the user name. This name must be unique; a
pre-existing user name is not accepted when
entered. The name must be min. 8 and max. 32
characters long and contain lower case letters
(a ... z), upper case letters (A ... Z), numbers
(0 ... 9), special characters !()*~'.-_ but no spaces.
WAGO I/O System Compact