WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
15.2.1.2.18 "DHCP Server Configuration" Page
The "DHCP Server Configuration" page displays the DHCP service settings.
"DHCP Server Configuration Bridge <n>" Group
Table 105: WBM "DHCP Server Configuration" Page – "DHCP Configuration Bridge <n>" Group
Parameter
Service active
Start IP for Range
End IP for Range
Lease time (min)
Static Hosts
Add Static Host
MAC Address or Hostname
Ip Address
Click the [Submit] button to apply the changes. The changes take effect
immediately.
To accept a new assignment click the [Add] button. The change takes effect
immediately.
Click [Delete] to delete an existing assignment. The change takes effect
immediately.
Explanation
Enable or disable the DHCP service for the interface
X<n>.
Enter the start value of the available IP address
range.
Enter the end value of the available IP address
range.
Specify the lease time here in seconds. 120 minutes
are entered by default.
This displays the static assignments of MAC IDs to
IP addresses. If no assignment was defined, "No
static hosts configured" is displayed.
You can add static MAC addresses or host names
and IP addresses.
Enter a new static assignment, e.g.,
"01:02:03:04:05:06=192.168.1.20" or
"hostname=192.168.1.20".
You can enter 15 assignments or host names.
Enter the IP address.
You can enter 15 IP addresses.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 203
Manual