Table 62: Wbm "Plc Runtime Information" Page - "Project Details" Group; Table 63: Wbm "Plc Runtime Information" Page - "Task N" Group(S) - WAGO Compact Controller 100 Manual

128 Appendix
"Project Details" Group
This group appears if the controller supports the CODESYS V2 runtime system
and CODESYS V2 is set as the runtime system.
Table 62: WBM "PLC Runtime Information" Page – "Project Details" Group
Parameter
Date
Title
Version
Author
Description
Checksum
"Task <n>" Group(s)
One dedicated group is displayed for each task when the PLC program is
executed. As a rule, only the group title is displayed with the task number, the
task name and the task ID.
This group(s) appear(s) if the controller supports the CODESYS V2 runtime
system and CODESYS V2 is set as the runtime system.
Table 63: WBM "PLC Runtime Information" Page – "Task n" Group(s)
Parameter
Cycle count
Cycle time (µsec)
Cycle time min (µsec)
Cycle time max (µsec)
Cycle time avg (µsec)
Status
Mode
Priority
Interval (msec)
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
751-9301 Compact Controller 100
Explanation
The last save date of the project is displayed.
The project information that the programmer has
entered in the PLC program is displayed here (in the
programming software under Project > Project
Information ...).
The information only appears in an executed PLC
program.
Descriptive texts up to 1024 characters long are
given under "Description."
The calculated checksum of the project is displayed.
Explanation
Number of task cycles since the system start
Currently measured task cycle time for the task
Minimum task cycle time for the task since the
system start
Maximum task cycle time for the task since the
system start
Average task cycle time since the system start
Task status (e.g., RUN, STOP)
Task execution mode (e.g., in cycles)
Set task priority
Set task interval
WAGO I/O System Compact