Toshiba e-STUDIO 2555C Service Manual page 602

Phenomenon of paper jamming
The leading edge of paper has
no scratches and the paper
stops before being fused.
Paper folded in one side and
fused during duplex printing
All
Parts to be replaced
Separation finger of the fuser
unit
Transfer belt
Transfer belt unit
Exit sensor
LGC board
DRV board
e-STUDIO2555C/3055C/3555C/4555C/5055C
ERROR CODE AND TROUBLESHOOTING
Check item
Fuser unit Check that the pressure release screw of the
pressure roller is securely tightened and pressure
is properly applied.
Transfer belt Replace the transfer belt.
Replace the transfer belt unit.
Check if toner adheres to the fuser entry guide.
Clean it if needed.
Exit sensor • Sensor check (Perform the input check: 03-
[ALL]OFF/[9]/[C])
• Actuator check
• Connector check
• Harness check
LGC board • Board check
• Connector check (CN355, CN361, CN362)
• Harness check
DRV board • Board check
• Connector check (CN450, CN451, CN461)
• Harness check
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
8 - 46
Measures
Remark