Toshiba e-STUDIO 2555C Service Manual page 379

Procedure 14
[0][5]
[Digital key]
[START]
[POWER]
(Code)
Notes:
The fuser belt temperature control at the adjustment mode is different from that at the normal
state. Therefore, the problem of fusing efficiency may be occurred in the test copy at the
adjustment mode. In that case, turn ON the power normally, leave the equipment for approx. 3
minutes after it has become ready state and then start up the adjustment mode again.
© 2012-2013 TOSHIBA TEC CORPORATION All rights reserved
(Input value)
[Digital key]
[START]
(Sub code)
[CLEAR]
(Corrects value)
5 - 13
[OK]
[FAX]
or
[INTERRUPT]
[START]
Stores value
(Test copy)
in RAM
[FUNCTION CLEAR]
(Corrects value)
e-STUDIO2555C/3055C/3555C/4555C/5055C
SELF-DIAGNOSTIC MODE
[POWER]
OFF/ON
(Exit)
5